Workplace Guidelines |
OSHA
The Occupational Safety and Health Administration (OSHA) has established an 8-hour time-weighted average (TWA) exposure limit of 5 micrograms of Cr(VI) per cubic meter of air (5 µg/m³). This is a considerable reduction from the previous permissible exposure limit (PEL) of 52 µg/m³ [Federal Register 2006].
OSHA's standard is based upon the best evidence currently available that at the previous PEL for Cr(VI), workers face a significant risk to material impairment of their health. The evidence in the record for this rulemaking indicates that workers exposed to Cr(VI) are at an increased risk of developing lung cancer. The record also indicates that occupational exposure to Cr(VI) may result in asthma and damage to the nasal epithelia and skin. [Federal Register 2006].
The final rule also contains ancillary provisions for worker protection such as
- requirements for exposure determination,
- preferred exposure control methods, including a compliance alternative for a small sector for which the new PEL is infeasible,
- respiratory protection,
- protective clothing and equipment,
- hygiene areas and practices,
- medical surveillance,
- record keeping, and
- start-up dates that include four years for the implementation of engineering controls to meet the PEL [Federal Register 2006].
For Cr(II) and Cr(III) compounds, the PEL is an 8-hour TWA of 500 µg Cr/m³. For chromium metal and for insoluble compounds, the PEL is 1,000 µg Cr/m³[OSHA 2006].
NIOSH
The National Institute for Occupational Safety and Health (NIOSH) has recommended a 10-hour TWA exposure limit for all Cr(VI) compounds of 1 µg Cr(VI)/m³. For chromium metal and Cr (II) and Cr(III) compounds, the recommended exposure limit is 500 µg/m³ as an 10-hour TWA [NIOSH 2005].
On the basis of current evidence, NIOSH considers all Cr(VI) compounds potential occupational carcinogens. |
Environmental Guidelines |
Air
The U.S. Environmental Protection Agency (EPA) regulates chromium emissions under the Clean Air Act of 1990. EPA uses technology-based standards for categories of industries, rather than numerical emissions standards, to reduce chromium levels in ambient air. These maximum achievable control technology (MACT) standards are based on emissions levels already achieved by the best-performing similar facilities.
Drinking Water
EPA has an enforceable maximum contaminant level of total chromium in drinking water of 100 µg/L (100 ppb) for public water systems [EPA 1999h].
| Table 1. Regulations and Guidelines for Chromium |
| Agency |
Focus |
Level |
Comments |
American Conference of Governmental Industrial Hygienists |
Air: workplace |
10 µg/m³ as Cr |
Advisory; TWA* to avoid carcinogenic risk from insoluble Cr(VI) compounds |
50 µg/m³ as Cr |
TWA for water-soluble Cr(VI) compounds |
500 µg/m³ as Cr |
TWA for chromium metal and Cr(III) compounds |
National Institute for Occupational Safety and Health |
Air: workplace |
1 µg/m³ as Cr |
Advisory; TWA (10-hour) for chromic acid and all Cr(VI) compounds |
500 µg/m³ as Cr |
Advisory; TWA (10-hour) for chromium metal and Cr(II) and Cr(III) compounds |
Occupational Safety and Health Administration |
Air: workplace |
5 µg/m³ as CrO3/m³ |
Regulation; PEL† for chromic acid and chromates, (8-hour TWA) |
500 µg/m³ as Cr |
PEL for Cr(II) and Cr(III) compounds (8-hour TWA) |
1,000 µg/m³ as Cr |
PEL for chromium metal and insoluble compounds (8-hour TWA) |
Environmental Protection Agency |
Air: environment |
Not available |
Chromium is listed as a hazardous pollutant |
Drinking water |
100 µg/L |
Regulation; current MCL‡ for total chromium |
*TWA (time-weighted average): TWA concentration for a normal workday and a 40-hour workweek to which nearly all workers may be repeatedly exposed.
†PEL (permissible exposure limit): highest level of chromium in air, to which a worker may be exposed, averaged over an 8-hour workday.
‡MCL (maximum contaminant level) enforceable level for drinking water. |
|
