Chapter 12 Figures
Figure 12.1.Piping Hookup for Inside Tank Installation
Figure 12.2. Piping Hookup for Buried Outside Tank
Figure 12.3. Heat Pump in Cooling Mode
Figure 12.4. Minimum Clearance for Pipeless Hot Air and Gravity Warm Air Furnace
Figure 12.5. Minimum Clearance for Steam or Hot Water Boiler and Mechanical Warm-air Furnace
Figure 12.6. Heating Ducts Covered With Asbestos Insulation
Figure 12.7. Typical Underfeed Coal Stoker Installation in Small Boilers
Figure 12.8. Cutaway View of Typical High-pressure Gun Burner
Figure 12.9. Gas-fired Boiler
Figure 12.10. Typical Gravity One-pipe Heating System
Figure 12.11. One-pipe Gravity Water Heating System
Figure 12.12. Two-pipe Gravity Water Heating System
Figure 12.13. Warm-air Convection Furnace
Figure 12.14. Cross-sectional View of Building Showing Forced-warm-air Heating System
Figure 12.15. Perforated-sleeve Burner
Figure 12.16. Condition of Burner Flame with Different Rates of Fuel Flow
Figure 12.17. Wall and Ceiling Clearance Reduction
Figure 12.18. Draft in Relation to Height of Chimney
Figure 12.19. Location and Operation of Typical Backdraft Diverter
Figure 12.20. Split-system Air Conditioner
Figure 12.21. External Air-conditioning Condenser Unit
Figure 12.22. Chimney Plan
Figure 12.23. Fireplace Construction
- Page last reviewed: October 1, 2009
- Page last updated: December 8, 2009
- Content source: